Sensor transmitter

The Milano external transmission module can be connected to any conventional electronic ruler or resistance output type drawstring to output RS485 digital signal. The module's aluminum alloy casing is small in size and easy to install and use.

Input signal: DC voltage signal (sensor 6-12V power supply, if 24V power supply, need to be equipped with our company's buck module, you can contact us for free)

Output signal: RS485 digital signal

The picture above shows the buck module provided by our company.

Transmitter size chart:

Transmitter wiring instructions:

Transmitter instructions:

1. The electronic ruler should be powered by a suitable power source. If the voltage is too low, the transmitter output signal cannot reach the maximum value, and the voltage is too high, which may cause damage to the transmitter.

2. It is strictly forbidden to use the module to soak water and oil.

3. Please follow the wiring instructions for proper wiring. If the wiring is wrong, the transmitter may be damaged.

4. The input signal and output signal of the transmitter have directionality. Before the wiring, the signal input end and the signal output end should be distinguished, and then correctly wired. Otherwise, the transmitter may be damaged.

5. The installation and use of the transmitter should avoid all kinds of signal interference areas and effectively ground, which can reduce the influence of external interference on the detection signal.