Sensor transmitter

The Milano external transmission module can be connected to any electronic ruler or miniature drawstring, and output 0-3.3V, 0-5V, 0-10V voltage signal, 4-20mA current signal. The plastic housing of the transmitter is straight out. The transmission module is small in size and easy to install and use.

Voltage module: The 12-24V working voltage is regulated and outputs 3.3V, 5V, 10V voltage signals, and there are three-wire system and four-wire system (12-24V power supply);

Current module: converts the voltage signal into a 4-20mA current signal, which has two-wire, three-wire and four-wire systems (15-24V power supply);

Transmitter size chart:

Transmitter wiring instructions:

Transmitter instructions:

1. The electronic ruler should be powered by a suitable power source. If the voltage is too low, the transmitter output signal cannot reach the maximum value, and the voltage is too high, which may cause damage to the transmitter.

2. It is strictly forbidden to use the module to soak water and oil.

3. Please follow the wiring instructions for proper wiring. If the wiring is wrong, the transmitter may be damaged.

4. The input signal and output signal of the transmitter have directionality. Before the wiring, the signal input end and the signal output end should be distinguished, and then correctly wired. Otherwise, the transmitter may be damaged.

5. The installation and use of the transmitter should avoid all kinds of signal interference areas and effectively ground, which can reduce the influence of external interference on the detection signal.