Sensor transmitter

Mirant water-proof transmission module can be connected to any conventional electronic ruler or resistance output rope ruler to output 0-3.3v, 0-5V, 0-10V voltage signal and 4-20mA current signal.

Voltage module: stabilize 12-24V working voltage and output 3.3V, 5V and 10V voltage signals, with three wire system and four wire system (12-24V power supply);

Current module: convert voltage signal to 4-20mA current signal, including two-wire system, three wire system and four wire system (15-24v power supply)

Transmitter dimension drawing:

Transmitter wiring instructions:

Transmitter instructions:

1. The electronic ruler shall be powered by a suitable power supply. If the voltage is too low, the output signal of the transmitter cannot reach the maximum value. If the voltage is too high, it is easy to damage the transmitter.

2. It is forbidden to use the transfer module in water or oil.

3. Please correctly wire according to the wiring instructions. If the wiring is wrong, the transmitter may be damaged.

4. The input signal and output signal of the transmitter are directional. Before wiring, distinguish the signal input end and signal output end, and then correctly wire. Otherwise, the transmitter may be damaged.

5. The installation and use of the transmitter should avoid all kinds of signal interference areas, and be effectively grounded to reduce the impact of external interference on the detection signal.